DIY Electric Skateboard Motor In Chrome (6380/170kv) Sold Out On Retail Site

Description

Chrome Electric Skateboard Motor (6380 170kv).
Connecting ports need to be soddered together but is not a tough task at all. This motor specifically is sold out on the retail site and is very desirable by fellow esk8 riders. Made for someone building a DIY BOARD.
Fits a 63mm motor mount
This motor is a beast with 4100 watts
80 amps max
12s volts max
5.06Nm max torque
170kv max rpm (voltage)
Motor weight 2.25lbs
Motor shaft - shadt bote diameter 8mm, 41.5 mm length.
Motor wire - 150mm silicone 12awg wire
NEEDS 5.5mm GOLD BULLET CONNECTOR FEMALE
Wire config.
Blue = A
Black = B
Yellow = C
Sensor wire - standard rc sensor wire JST - ZH 6pin 1.5mm pitch
Internal pcb with 120 degree hall effect sensors
Motor can be used with or without A sensor. Sensor less operation is most common.
VESC sensor wires required to use with VESC.
Wire configuration:
Red equals 5V
White equals temp
Blue equals a
Yellow equals C
Green equals B
Black equals GND
Any additional questions please dm god bless.