XADO 1 Stage Maximum Engine Oil Additive Wear Protection Engine Repair

Description

start_elivehelp_btncode
end_elivehelp_btncode
All Orders received before 2 PM Central Time are SHIPPED THE SAME DAY
Atomic Metal Conditioner Maximum with 1 Stage Revitalizant is an innovative 3-component Engine Oil Additive specially formulated for treating vital engine parts in cars with oil system capacity up to 5 qt. Due to Revitalizant the product reduces friction, rebuilds worn metal in engine parts and creates protective coating against future wear, thus providing tools-free restoration and anti-wear protection. XADO Additive Supplement application prolongs the life of your engine and allows avoiding expensive repairs in the future.
Application
Make sure the automobile engine is warmed up to normal operating temperature.
Turn off the vehicle.
Shake the bottle for one minute and ensure it is at room temperature so that contents flow freely.
Pour the contents into the engine oil reservoir.
Start the car and let the engine idle for five minutes.
Drive as you normally would. It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended. Granules of Revitalizant completely dissolve in motor oil at normal operating temperature.
1 Bottle (225 ml) is enough for engine with an oil capacity of 5 qt. Larger vehicles with higher oil capacities may require more.
Key Features
Rebuilds worn engine metal and reverses metal wear
Increases power and acceleration
Reduces fuel consumption Increases engine cylinders’ compression
Decreases noise and vibrations
Restores lost oil pressure up to nominal level
Protects metal parts from overheating and overloading
Improves oil lubricating properties and tribological characteristics of engine parts Increases engine service life
Reduce exhaust emissions toxicity (CO2, CO, HC)
One treatment lasts for 60,000 miles
Note
Atomic Metal Conditioner Maximum with 1 Stage Revitalizant works in all gasoline-powered, natural-gas and diesel engines of passenger cars and trucks and 4-stroke motorcycles with oil system up to 5 Quarts
Can be combined with all types of motor oils, from full synthetic to mineral oils It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended. Repeated application of Atomic Metal Conditioner Maximum is recommended after 60,000 miles. For the highest level of protection for your vehicle’s engine use XADO Atomic Oil or Atomic Metal Conditioner High Way during each oil change in the future. AMC Highway contains 5.5% (RF5.5) of the active ingredient necessary for 1 complete revitalization cycle
Revitalizant ® or Atomic Metal Conditioner. Which one to choose?
When searching for the best product for your vehicle’s protection and restoration the answer is obvious. It is AMC Maximum. If we compare products with the Revitalizant®, it’s better to compare similar top products. They are 1 Stage Engine Revitalizant® and AMC Maximum.
Both products are based on the 3d generation 1 Stage Revitalizant®. Both products have 1 Stage Revitalizant® in its formula, but due to the innovative 3-component composition of Metal conditioner and 2D sliding agent, AMC Maximum possesses new properties which set it apart from 1 Stage Engine Revitalizant®.
Metal Conditioner is like polymer molecules (bearings) which stick to the engine operating surfaces. Introduction of this compound (polymer bearings) into AMC Maximum has provided additional level of anti-wear protection for the engine parts’ surfaces. Metal Conditioner strengths the oil film and prevents its disruption under high loads. Also the oil film remains on the engine surfaces for a long time due to presence of Metal Conditioner thus preventing surfaces from wear during cold starts. The effect of Metal Conditioner application can be observed from the first miles of run!